Details
With the use of this 3 part conversion kit, you can easily convert your CARVER Competition Glock Mount to an Angle Cmore Mount. The 3 unique parts included in this kit will replace the parts on the Competition Mount. All parts and new screws are included in the kit. Each conversion kit will include the following:
- Part A: Cmore Angle Part
- Part B: Cmore Base Plate
- Part C: Replacement left sideplate
The replacement left sideplate has room to add your CARVER Thumbrest. Please note that the Angle Conversion Left Sideplate can only be used with the Angle Mounting system.
Assembly is easy: - 1. Remove current Competition Mount from Glock
- 2. Slowly remove screws holding the left sideplate to the underlug (4 screws). These screws have had blue loctite added to them. It's suggested that you use heat from 400 to 450 degrees to weaken the loctite. You can use the tip of a soldering iron as well. Caution. Don't burn yourself.
- 3. Remove the 3 screws on the right side of the mount that holds the top base to the right sideplate.
- 4. Once you have the right sideplate and the underlug less the insert available, install the left sideplate by using the (4) new screws included with blue loctite to attach the left sideplate to the underlug. Tighten loosely at this time.
- 5. Using (3) 10-40 SHC screws included install Part B, Cmore baseplate to the right sideplate, making sure that blue loctite is used on the screws. Tighten loosely at this time.
- 6. Place Part A, Cmore Angle Upright on top of Part B and use the (5) SHC screws included to secure the Angle Mount to the left sideplate. Use blue loctite. Tighen loosely at this time.
- 7. Once parts A-B+C are installed, tighten screws to snug. Caution, do not overtighen or you will snap the 10-40 SHC steel screws.
- 8. Once the mount is assembled, install your C-more and then reinstall the mount to your Glock following regular mount removal/reinstallation steps.
Conversion kits are available in either Black or Silver Type 2 Annodizing.